BTT SKR Mini E3 V2
Max filament units: 4
MCU Name: 3ms
BOM
| Name | Price | Quantity | Link | Notes |
|---|---|---|---|---|
| SKR Mini E3 V2 | $34.99 | 1 | Amazon | |
| Duponts | $9.99 | 1 | Amazon | These wires are only sufficient to run steppers, not heaters |
| 12V PSU | $7.39 | 1 | Amazon | This PSU is only sufficient to run steppers, not heaters |
Wiring
Route the wires from the NEMA17's to the controller board. Follow this table to determine which port to plug the motors into:
| Filament Unit # | Motor Port |
|---|---|
| 0 | XM |
| 1 | YM |
| 2 | ZAM or ZBM |
| 3 | E0M |
Now, grab your 12V PSU and two M-M duponts, one red and one black (M-M means that there is metal coming out of both ends of the cable). Plug the PSU into the wall, but don't plug the screw terminals into the PSU (the screw terminals have green)
- Plug the red wire into the positive terminal of the screw terminals
-
Plug the black wire into the negative terminal of the screw terminals
Danger
These dupont cables are too thin to run much more than the stepper motors. If you run a heater or other power-intensive device off of the SKR board, the duponts and/or PSU can melt/catch fire. To reduce the risk of this, you can double up on the duponts or get thicker wires.
-
Following this image, choose either the DCIN or POWER input
- Route the two wires inside closest to your chosen input
- Using the markings on the board, plug the red wire into the positive terminal on the SKR
- Using the markings on the board, plug the black wire into the negative terminal on the SKR
-
Verify all connections
Warning
If the wires are plugged into the wrong place, or swapped polarities, your SKR, Stepper motors, and/or PSU can be badly damaged.
-
Plug the PSU screw terminals into the PSU wire
If the SKR lights up, you wired it correctly!
Finally, plug the SKR into your Klipper host with the blue cable that came with it.