G-Codes

KlipperMaintenance provides a few helper GCodes to manage your maintenance. Follow this guide to learn how to use them.

MAINTAIN_STATUS

Shows the current status of maintenance. Accepts no parameters. Using the example from Configuration and assuming air filter is expired, here is an example:

Input

MAINTAIN_STATUS

Output

XY smooth rods: 200h remaining
Maintenance "Air filter" Expired!
Replace HEPA and charcoal filters
Extruder maintenance: 400m remaining

CHECK_MAINTENANCE

Shows the current status of provided maintenance. Example:

Input

CHECK_MAINTENANCE NAME=xyrods

Output

Maintenance xyrods Status:
Next maintenance in 200h
Maintenance message: Lubricate XY smooth rods

UPDATE_MAINTENANCE

Marks the provided maintenance as complete. Example:

input

UPDATE_MAINTENANCE NAME=xyrods

This resets the maintenance timer for the xyrods maintenance.

You can also pass a HOURS parameter to set the current amount of working hours. Example:

Your threshold for xyrods is set to 350 print hours. You have printed for 100 hours so far.

Run the following command:

input

UPDATE_MAINTENANCE NAME=xyrods HOURS=100

This will ensure that KlipperMaintenance reminds you to lubricate your XY rods after 250 hours, not 350.